2/12/2019 In class

1/14/2018

So i havnt had much time to work on my drone tutorial lately just picked up where i left off on thursday

so i am still working on the drone arm and i noticed i seem to be missing an edge loop near the top of the smaller cylinder

So i took this as a challenge to figure out the problem versus using a save from the pluralsight

so i selected the one vertice and beveled it

enlarged it

then it took be a bit to understand the extrude tools

then finished off today with making that little notch at the bottom.

i didnt do too much today but i feel like i learned alot today and how to solve a problem i shouldnt have had.